Set enabled condition to 0, then set output to and select the 1 radio button.In station menu, make sure that Enable/Disable, and Read stopped train are both checked.Connect both input and output terminals of the combinator to the station.Place Decider Combinator near the station.You may chose any signals you wish, these are the two signals i am not likely to use on my dedicated train circuit network. Because I have a HUGE imbalance in product, especially in oil processing, so I want to sort this out once and for all. If it's above a certain level, the power switch should kick open and stop the system until there's a drop in fluid again. So I want to hook up this tank to read the contents. – station output signal, and decider input signal Troubled Engineer seeks help with circuit network. – station input signal, and also decider output signal We can use all this to avoid waiting lines just about anywhere, where multiple trains tend to come together and create temporary congestion, and slowing things down. While every other train with that station in its list, will automatically reroute to next available station whenever it encounters disabled station in its stop queue. Since the train is already standing still at the station, disabling the station does not affect it. Train ID’s are always greater than zero, so the circuit signal is always raised whenever train is stopped at a station. This method uses the fact that stations are capable of reporting the train ID back to the circuit network. Only requirement beside Railway is Circuit Network research. Different circuit wire color is used to isolate one network from the other, and to isolate stations from eachother so only one specific station gets disabled. This solution works standalone, and as a part of existing circuit network.
#Factorio circuit network how to#
I have found multiple ways how to do this online, but they were all either complicated, or they wouldn’t/couldn’t work with pre-existing circuit network. I’ve been looking for a way to disable station when train is present to prevent congestion at my train refueling depot, while packing more trains closer together and preventing deadlocks. This guide describes simple method of how to disable train station while train is present, so all other trains will bypass that station while existing train is present.
0 kommentar(er)
